GoPro Cameras For Dummies
Book image
Explore Book Buy On Amazon

GoPro has a lot of mounts — one for every occasion and situation. There are mounts for your ski pole, the roll bar of your all-terrain vehicle, and the top of your bicycle helmet. There’s even one that your dog can wear as a harness.

GoPro mounts need a little explanation for the pieces inside the box that apply to mounting:

  • Pivot arms: The pivot arms come in two varieties: straight and angled (see this figure). You use them to put the camera farther from the mount or to rotate it.

    When you add an angled extension, it changes the mount by 90 degrees, so each one that you add turns the camera. You can add as many arms as you need, joining them with the thumbscrews that come in the GoPro package.

  • Quick-release buckle: You get two of them, one of which is slightly larger and more flexible than the other. The pivot arms attach to many of the mounts as well as the quick-release buckle that locks into some of the mounts. When using the quick-release buckle, you just slide and clip, as shown here.

  • Double-stick base plates: One of the adhesive mounts that accommodates the quick-release buckle is flat, and the other is slightly curved. The quick-release buckle can be used with either adhesive mount.

    These plates are permanent, so be sure to put them where you want them to stay.

    Even though the base-plate seal is permanent, you may have to wait a while for it to set — as much as 24 hours during cold weather.


About This Article

This article can be found in the category: