Knitting & Crocheting All-in-One For Dummies
Book image
Explore Book Buy On Amazon
When you cast on with the two-strand method in knitting, you need only the RH needle. The two-strand cast-on method (or long-tail method) is a great all-around cast-on for your knitting repertoire. This cast-on method is elastic, attractive, and easy to knit from.

Measure off enough yarn for the bottom part of your piece and make a slip knot on your needle.

Measure off enough yarn for the bottom part of your piece and make a slip knot on your needle.

To make the slip knot (the first stitch), make a pretzel-shaped loop and place your needle into the loop (a.) and pull gently on both ends of the yarn until the stitch is firmly on the needle (b.) but still slides easily back and forth.

To figure how long the “tail” should be, you need approximately 1 inch for every stitch you cast on, plus a little extra. Alternatively, you can measure the bottom of the knitted piece and multiply this number by 4.

Holding the needle in your right hand with the tip pointing away from your hand, insert your left thumb and index finger into the “tent” formed by the two yarn ends falling from the slip knot on your needle.

This position might seem a bit awkward, but it’ll be second nature when you become a knitting know-it-all!

With your left hand’s ring and pinkie fingers, catch the yarn ends and hold them to your palm.

With your left hand’s ring and pinkie fingers, catch the yarn ends and hold them to your palm.

This step prevents the ends from flapping around as you work.

With your right hand, pull the needle between your left thumb and index finger.

You don’t want the “tent” sides to be droopy.

With the needle tip, go around the yarn on your thumb from the left, as shown in (a), then go around the yarn on your index finger from the right (b), and pull the new loop through (c).

With the needle tip, go around the yarn on your thumb from the left, as shown in (a), then go around the yarn on your index finger from the right (b), and pull the new loop through (c).

This looks complicated, but you’ll get the hang of it.

Tighten this new loop (your first cast-on stitch!) onto the needle — but not too tight.

Tighten this new loop (your first cast-on stitch!) onto the needle — but not too tight.

If you don’t let go of the yarn after creating the stitch, you can use your thumb to tighten the stitch onto your needle.

Although this is your first cast-on stitch, it’s technically the second stitch on the RH needle; the initial slip knot counts as the first real stitch.

Repeat Steps 5 and 6 until you have the number of stitches you need.

Repeat Steps 5 and 6 until you have the number of stitches you need.

If you need to put your work down, or if you lose your place, you may have to pull the stitches off the needle and start from Step 2 again.

About This Article

This article is from the book:

About the book authors:

Pam Allen is a knitwear designer and founder of Quince & Co. Shannon Okey is an author and knitwear designer. Find her at knitgrrl.com. Tracy Barr has been an editor, editorial manager, writer, and consultant on several Dummies books. Marlaina "Marly" Bird hosts her own YouTube channel, where she instructs viewers on knitting and crochet. Susan Brittain is a knitwear pattern designer and writer. Karen Manthey edits crochet diagrams for numerous books, magazines, yarn companies, and designers. Manthey was an editor at All American Crafts for 20 years.

This article can be found in the category: