Replacing vinyl floor tiles is pretty easy, especially if you saved extra tiles when the floor was installed. If not, scavenge a replacement vinyl tile from somewhere that won't be noticed, such as inside a closet.


Gather your tools: Replacement vinyl tile, heat gun or iron, tile adhesive, putty knife, notched trowel, mineral spirits, rags, rolling pin.

You need just a small tub of tile adhesive.


Apply heat to the damaged tile with the heat gun or warm iron to soften the adhesive underneath.

You want to make the adhesive soft, but don’t melt the vinyl.


Lift out the old tile by using the putty knife.

Start at one corner or side and work your way to the center of the tile.


Use mineral spirits to soften the old adhesive on the floor.

Mineral spirits work great to dissolve the adhesive.


Scrape away the old adhesive.

Use your putty knife or a scraper to scrape away the gooey adhesive.


Trowel on some adhesive to the new tile.

Coat the underside of the new tile with adhesive.


Put the new tile in place.

Be sure to get the tile positioned just right.


Roll the tile with the rolling pin.

Press hard as you roll the pin to get rid of any trapped air pockets, which can cause the tile to lift up.


Dampen a rag with mineral spirits and wipe away excess adhesive around the edges of the tile.

Dirt, pet hair, and more will stick to any bit of residual adhesive, so clean thoroughly.

If you plan to use the rolling pin for making sugar cookies again, be sure to wrap the rolling pin in kitchen plastic wrap. This way any adhesive that squeezes out will stick to the plastic wrap and not the rolling pin.