How to Create a 3D Template in AutoCAD 2014
How to Create a New Layer in AutoCAD 2014
How to Create a 2D View from a 3D Model in AutoCAD 2014

How to Use the Join Command in AutoCAD 2014

In AutoCAD 2014, you use the Join command to fill gaps between lines, arcs, elliptical arcs, open splines, 2D and 3D polylines, and helixes. If the lines are collinear (they lie in the same straight line) or the arcs, splines, polylines, or elliptical arcs are on a similarly curved path, Join creates a single new entity to replace the existing separate pieces.

Objects to be joined must be collinear or else their ends must be coincident. You can’t join noncollinear objects that have gaps between them or that cross or overlap.


The following steps describe how to use the Join command:

  1. Click the Modify panel title at the bottom edge of the Ribbon’s Home tab to open the Modify panel’s slideout, and then click the Join button.

    If you foresee doing a lot of joinery, you can pin open the slideout. AutoCAD prompts you to select the source object.

  2. Select the source object — that is, the object you want to join other objects to.

    AutoCAD prompts you according to the object type you selected. If you select a line, the command line or Dynamic Input tooltip shows this message:

    Select source object or multiple objects to join at once:
  3. Select valid objects to join to the original source object.

    For example, if you selected a line as the source object, AutoCAD continues prompting for additional adjoining lines until you press Enter to end the object selection.

  4. Press Enter to end the command.

    AutoCAD joins the selected objects into a single object. The new object inherits relevant properties, such as the layer or linetype of the source object.

You aren’t limited to selecting a single object at the first prompt. If you select multiple objects by using windowing, Join joins whatever objects it can and rejects those that it can’t.

You can turn an arc into a circle or an elliptical arc into a full ellipse with Join’s cLose option.

  • Add a Comment
  • Print
  • Share
blog comments powered by Disqus
How to Use Geometric Constraints in AutoCAD 2014
How to Add Crosshatching to a Drawing in AutoCAD 2014
How to Set Your Drawing Units in AutoCAD 2014
AutoCAD 2011’s Top Keyboard Shortcuts
AutoCAD 2014 Precision Procedures