How to Fix a Squeaky Floor with a Metal Cleat
How to Fix Scratches In Hardwood Floors
How to Stain and Seal Hardwood Floors

How to Get Wood Floors Ready for Sanding

Before refinishing a hardwood floor, you need to know how to get the floors ready for sanding. The way you get floors ready for sanding affects the final finish, so prepare carefully. The sanding process also creates fine sawdust that can permeate the house if you’re not painstaking in your preparations.

1

Thoroughly clean the hardwood floor.

Dirt and grit on the floor can create gouges in the floor when the floor is sanded.

2

Seal off the work area.

Tape dropcloths made of heavy vinyl at doorways and cabinets to seal off the work area.

3

Pull the base shoe moldings away from the wall enough to see the closest nail.

Carefully drive the pry bar between the floor and the molding and lever the molding away from the wall a bit. Peek between the molding and wall and find the closest nail.

4

Position the pry bar as close to the nail as possible and use a hammer to help remove base shoe moldings. (Use a nail set to drive a stubborn nail through the molding.)

Remove the pry bar and reinsert it as close to the nail as possible. Pry the molding loose at each nail to avoid breaking the molding. If a nail refuses to budge, use a nail set to drive the nail through the molding.

Sweep the floor again, if necessary.

5

Before you begin sanding, open the windows and get anyone not wearing protection out of the house.

Sawdust can be very damaging to the lungs, especially to kids and folks with respiratory conditions.

 
blog comments powered by Disqus
How to Fix a Squeaky Floor Caused by Gaps between the Subfloor and Finished Floor
How to Fix a Squeaky Floor Caused by Gaps between the Subfloor and Joist
How to Paint Wood Floors
How to Clean Laminate Floors
How to Refinish a Hardwood Floor
Advertisement

Inside Dummies.com