Auto Repair For Dummies, 2nd Edition
Book image
Explore Book Buy On Amazon

You can actually read your spark plugs for valuable “clues” about how your engine is operating. If your plugs indicate that something is seriously wrong with your engine, ask a professional for an opinion.

To read a spark plug and assess engine troubles, you first have to remove it. Use a spark plug wrench with an extender. Once you get the socket over the spark plug, place your hand over the head of the wrench, grasping the head firmly and pull the handle, hitting it gently with the palm of your hand to get it going.

image0.jpg

Once you have the plug in your hand, check out its various parts to look for tell-tale signs of trouble. The following figure can help you identify the different parts of a spark plug.

image1.jpg

You should also check the gap between the center electrode and the side electrode. Take your wire or taper feeler gauge and locate the proper wire and slide it into that gap. If the gauge has a lot of room to wiggle around, your old plug may have worn down its center electrode, causing a gap that’s too large. If the gauge can’t fit between the center and side electrodes, the gap is too small, which means that the spark plug isn’t burning the fuel/air mixture efficiently.

Compare the state of your spark plug with the table below to diagnose any problems.

What Your Old Spark Plugs Tell You about Your Vehicle
Condition Clues Probable Causes Remedies
Normal plug Brown or grayish- tan deposit on side electrode. Everything’s fine. Just clean and regap the plug.
Carbon-fouled plug Black, dry, fluffy soot on insulator tip and electrodes. Overly rich fuel/air mixture, dirty air filter, too much driving at low speeds, or idling for a long time. Switch to “hotter” plug. (The higher the plug number, the hotter the plug.)
Oil-fouled plug Wet, black, oily deposits on insulator tip and electrodes. Oil may be leaking into cylinders past worn pistons or poorly adjusted or worn valves. Clean and regap the plug, or replace it, but find out where the leak is coming from.
Burned plug Blisters on insulator tip, melted electrodes, burned stuff. Engine overheating, gap is too wide, wrong or loose plugs, overly lean fuel/air mixture, or incorrect timing. Replace the plug.
Worn plug Severely eroded or worn electrodes. Plug has been in there too long. Replace the plug.
Check all your spark plugs, but work on only one plug at a time, and don’t remove a plug unless the one you just dealt with — or its replacement — is safely back in the engine.

To keep your engine operating efficiently, don’t mix plugs in varying states of wear. Either replace all the plugs with new ones or clean and reinstall all the old ones. If you find that a few of your old plugs aren’t too worn and are in fairly good shape but you need to replace the others, clean and regap the salvageable plugs and store them in your trunk compartment tool kit for emergencies.

Sometimes you can cure a problem — such as carbon-fouled plugs — by going to a hotter- or cooler-burning plug. You can identify these by the plug number: The higher the number, the hotter the plug. Never go more than one step hotter or cooler at a time.

About This Article

This article is from the book:

About the book author:

Deanna Sclar is an acclaimed auto repair expert. She has appeared on hundreds of radio and TV shows, including NBC's Today show and the NBCNightly News. Sclar lectures internationally on the ecological impact of vehicles and is active in promoting residential solar energy programs. Sclar is also the author of Buying a Car For Dummies.

This article can be found in the category: