Electronics Projects: How to Check the Status of a Switch in PBASIC
Digital Electronics: DB25 Connectors in a Parallel-Port Circuit
Prototype an Electronic Coin-toss Prep: Specs, Parts, and Tools

Electronics Projects: How to Ground Your Radio Antenna

A good ground connection is every bit as important as a good antenna in do-it-yourself radio electronics. The best way to create a good ground connection is to use a metal cold water pipe.

Assuming you placed your antenna outdoors, you may be lucky enough to find an outdoor water faucet near the end of the antenna. Then, you can connect one end of a length of hookup wire to the water pipe and the other end to your crystal radio. (Note that this won’t work if the home uses plastic pipe; it will only work with metal pipe.)

If you can’t find a water pipe, get a length of metal rebar and pound it into the ground. The deeper you go, the better the ground connection.

The easiest way to connect a wire to a water pipe (or a piece of rebar) is to use a pipe clamp, which you can find in the plumbing section of any hardware store.

Use some coarse sandpaper to sand the pipe where you attach the clamp to improve the electrical connection, especially if the pipe has been painted or varnished. Strip an inch or two of insulation from the end of your ground wire and wrap it around the clamp, then slip the clamp around the water pipe and tighten it down.

  • Add a Comment
  • Print
  • Share
blog comments powered by Disqus
Electronics Projects: How to Use FOR Loops in PBASIC Code
Electronics Projects: How to Make a One-Shot Timer
Electronics Projects: How to Connect a Push Button to a BASIC Stamp
Electronics Projects: Block DC while Passing AC
Electronics Projects: How to Build a Parallel-Port LED Flasher

Inside Dummies.com